Terraced Roof Plate

  1. Terraced Roof Plate

Product Detail

Bare stone wool plates produced with high compression strength for terrace roofs and walkways and for metal and wooden roofs of various slopes.

Application Areas and Principles

After the surface finish is made on the terraces and terrace roofs, the joints of the vapor barrier material will be glued by overlapping 10 cm. Then, the stone wool terrace plate will be laid on the surface and the polyethylene sheet will be laid on top. Slope concrete with trowel coating will be poured. After the corner bevels are completed, the waterproofing process will be blocked by overlapping the joints with the bitumen sheeting such as PVC, TPO or EPDM membranes and turning them into the parapets by gluing and sealing. After the water intake test, geotextile felt will be laid and protection and coating layers will be made. On top of the trapezoid metal roof, a layer of vapor barrier polyethylene will be placed by overlapping joints by 10 cm. Single or
double layer of stone wool plates will be fixed with trapezoidal screws. In cases where it is applied in 2 layers, stone wool is applied vertically and horizontally. As waterproofing layer, PVC, TPO or EPDM membranes is applied.

Technical Table

Product IDDensityThicknessDimensions
(mm x mm)
Package (piece)m²/Package
TWTÇL1503015030600x120085.761.6662.833
TWTÇL1504015040600x120064.321.2502.125
TWTÇL1505015050600x120042.881.0001.700
TWTÇL1506015060600x120042.888331.416
TWTÇL1507015070600x120032.167151.214
TWTÇL1508015080600x120032.166251.063
TWTÇL150100150100600x120032.16500850
TWTÇL150120150120600x120021.44416700

Related Products

Reminders on Loading, Unloading, Transport and Storage:

  • It should be done in closed areas in rainy weather.
  • Stretch the canvas even when hey are shipped for short distances.
  • It should be stored in the package and the damaged package should not be used.
  • Packages should not be stacked on top of each other.
  • The products are not be stepped on or used as a step.
  • Before pulling with rope, hard cardboard with dimensions of 50×20 cm size should be
    placed under the rope.
  • Storage area should be closed to prevent leakage during rain, flooding etc.
  • The storage floor must be flat and non-slippery.
  • Loading and unloading should be done with the roof crane.
  • Plates should be carefully transported to the application area by two persons.
Menu